It is an urethaned alkyd high gloss enamel with excellent retention of colour and good outdoor performance. It has good elasticity, resistance to mineral oils and aliphatic hydrocarbons.

Fields of Application:

As a general use finishing coat on steel and wood in industrial, rural and marine atmospheres with moderate chemical
aggression. For structural steel, iron gates, doors, etc., and for any iron and wooden surface, both in- or outdoors

DRYING:4 hours
APPLICATION METHODS: Brush, Roller, Airless and Spray-gun
Finish:Gloss

GENERAL REMARKS:
Carefully stir the contents in the pack. The surfaces to be painted have to be clean, dry and sound.
BARE SURFACES:
Steel: Previously apply one of the primers of our alkyd range, following directions for use and keeping the overcoating intervals. Then apply a suitable number of paint coats, depending on requirements.

Non ferrous metals: Previously apply one coat of 804 or 871 Primer. To improve adhesion, some light sanding on metal may be necessary.

Other surfaces: Seek advice

In all cases
Indoors: 1 - 2 coats (35 - 70 μ)
Outdoors: 2 - 3 coats (70 - 100 μ)
In order to improve the resistance to outdoor conditions, 3 enamel coats are recommended.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN GOOD CONDITION:
If overcoating on well adhered systems, remove grease, oils and dirt (freshwater jet, thinner, etc.) Let  to dry and apply one or two coats of paint, depending on requirements.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN POOR CONDITION:
If the previous paint system is badly adhered and/or has rust, it has to be removed by sandblasting up to Sa 2 ½  grade of the ISO 8501-1 standard or, alternatively, by hand or mechanical scraping or brushing up to ST-3 grade of this same standard. Then patch with the suitable primer, preferably by brush, and apply the required number of paint coats