Base to be tinted with TITAN Servicolor System. It is a satin urethaned alkyd enamel with great resistance outdoors. It has good elasticity. It has good resistance to mineral oils and aliphatic hydrocarbons.

Fields of Application:
As a general use finishing coat on steel and wood in industrial and marine atmospheres with moderate chemical aggression.
Structural steel, iron gates, doors, etc, and any iron and wooden surfaces, both in and  outdoors

DRYING:3 - 4 hours
APPLICATION METHODS: Brush, Roller, Spray-gun and Airless (The data quoted are only hints)
Finish:Satin. Gloss 60º 20 - 25

GENERAL REMARKS: Carefully stir the contents in the pack. The surfaces to be painted have to be clean, dry and sound.

BARE SURFACES:

Steel: Previously apply one of the primers of our alkyd range, following directions for use and keeping the overcoating intervals. Then apply a suitable number of enamel coats, depending on requirements.

Non ferrous metals: Previously apply one coat of 804 or 871 Primer. To improve adhesion, some light sanding on metal may be necessary.

Other surfaces: Seek advice

In all cases:
Indoors:    
1 - 2 coats (35 - 70 microns)
Outdoors:
 2 - 3 coats (70 - 100 microns)
In order to improve resistance to outdoor conditions, 3 enamel coats are recommended.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN GOOD CONDITION:
If overcoating on well adhered systems, remove grease, oils and dirt (freshwater jet, etc.). Let to dry and apply one or two coats of paint, depending on requirements.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN POOR CONDITION:
If the previous paint system is badly adhered, it has to be removed by sandblasting up to Sa 2 ½  grade of the ISO 8501-1 standard or, alternatively, by hand or mechanical scraping or brushing up to ST-3 grade of this same standard. Then patch with the suitable primer, preferably by brush, and apply the required number of paint coats