Ultra tough crystal clear protection for interior floors. This is the hardest of all 'one pack' varnishes. An ultra hard, high quality coating with a satin or dead flat finish that dries to a crystal clear film with extremely good sanding properties allowing a very high quality of finish to be obtained. Formulatated for floors and areas of high wear.

When using dead flat finish, if a very high level of durability and stain resistance is required, apply one or two coats of Floor Varnish Satin Finish followed by one or two coats of Floor Varnish Dead Flat Finish.

Ideal for
• wooden floors • cork tiles • stone • slate • brick • quarry tiles • wooden worktops

Drying time: 30-60 minutes
Recoat time: 1-2 hours
Curing time: 16 hours in ideal conditions. Allow 48 hours before heavy use.
Coverage: 10-20 square metres per litre
Available in: 1 litre • 2 litre • 4 litre

Preparation
Thoroughly sand in the direction of the grain to remove all traces of old finishes and dirt, oil and contamination. Old floors can be impregnated with wax and grease - this will cause failure and must be completely removed. On new wood or if the old finish is in good condition, lightly sand to provide a key. Thoroughly clean after sanding.

Application
Ensure the product is well mixed. Apply 3 coats of varnish. On new wood and porous surfaces dilute the first coat 50% with water. Lightly sand wood in between applications to remove any raising of the grain that may have occurred.

Caution
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.