Enamel based on highly resistant long-oil alkyd resins. Especially intended for the protection of structures in marine environments and for the maintenance of fishing boats. Non-slip shades for boat decks contains neither sand nor marble-like stone. The low density additive makes possible a homogeneous paint structure and provides easy application, and uniform finishes

Fields of Application:
Indoor and outdoor enamel for the maintenance of suitably primed iron, polyester and wooden surfaces.
Non-slipping shades are especially suitable for boat decks, stairs, ramps, etc. Resistant to rubbing, grease, oil and marine atmospheres. (Complete cross-linking and abrasion resistance are reached after 7 days)

Product Type: Alkyd
Finish: Gloss
Colour (UNE 48073): White and colour range
Coverage: 12 - 16 m2/l
Drying at 23ºC 60 % RH (UNE 48301): 5 - 7 hours
Recoat time at 23ºC 60% HR (UNE 48283): 24 hours
Fields of Application: Brush, roller and spray-gun
Thinning: Brush and roller: 0 - 5%, Spray-gun: 5 - 15%
Equipment Cleaning: TITAN Thinner and Grease Thinner or Turpentine
Application Temperature, RH<80%: +15ºC - +40ºC
Flash Point (UNE EN ISO 3679): 42 ºC
Pack sizes: 4 l and 750 ml.

Carefully stir the contents in the can before use. The surface has to be sanded, clean, dry and salt-free (wash it). Do not paint if
the surface is under direct sunlight or if it has dew on it.

BARE SURFACES:
Wood:
Superstructure: Apply 1 - 2 coats of TITAN Sealing Primer, TITAN Multi-Purpose Primer or TITAN YATE Epoxy Primer. Finish with Enamel for Fishing Boats.

Metal:
Superstructure:
Apply 1 coat of TITAN YATE Epoxy Primer, thinned with 20% TITAN YATE Thinner. After 24 hours, apply 2 coats of TITAN YATE M-150 Epoxy Primer. By 72 hours, finish with Enamel for Fishing Boats.

Polyester:

Superstructure: Apply TITAN YATE Epoxy Primer or TITAN Red Lead for Fishing Boats. Finish with Enamel for Fishing Boats.

In all cases, for indoor surfaces, 2 coats of Enamel for Fishing Boats are enough. For outdoor surfaces, 3 coats are required.Clean, sand and directly apply.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN GOOD CONDITION:
Wash, sand and directly apply the Enamel for Fishing Boats.

MAINTENANCE OF PREVIOUSLY COATED SURFACES IN POOR CONDITION:
Thoroughly remove all previous coats and afterwards proceed as for a bare surface.