Stone and Brick Protector Varnish POLYVINE
- Dead flat finish
- Waterproofs brick and stone
- Suppresses formation of salts on natural masonry surfaces
- Improves weatherability
- A moisture barrier
- Seals off the surface
- Resists penetration of grease, oil, acids, alkaline, salts
- Easily cleaned with mild soap and water
Delivery at your place
Order phone number 210 008 5999
Absorbed into the substrate, this high performance coating protects interior and exterior stone and brick for a completely natural finish. A high performance water-based masonry protector and water repellent. Dries to a dead flat finish, which retains the natural look of the substrate. Protection of the surface begins immediately after application and is complete in approximately 24 hours.
Ideal for
• stone • plaster • brick • slate • flagstones • fireplaces • exposed stone walls • brick walls • stone window ledges
Drying time: 15 minutes to 1 hour depending on temperature
Coverage: 15-20 square metres per litre , depending on the porosity of the material
Available in: 1 litre • 4 litre
Preparation
Do not use in temperatures below 5°c/40°f or in very high humidity. Stone and brick protector should be used as supplied, without dilution, by brush, spray or roller.
Application
Mix well before use.
For general applications on masonry, brickwork and stone, a single application will be sufficient.
Caution
Always test on a trial area before application. Apply evenly and do not allow to pool in crevices. Test for clarity over dark colours.
NOTE: A chemical reaction could take place on some substrates such as glass, glazed surfaces, lead or aluminium. Mask these materials before application. In case of contact, rinse thoroughly with water immediately.
-
DESCRIPTION
Absorbed into the substrate, this high performance coating protects interior and exterior stone and brick for a completely natural finish. A high performance water-based masonry protector and water repellent. Dries to a dead flat finish, which retains the natural look of the substrate. Protection of the surface begins immediately after application and is complete in approximately 24 hours.
Ideal for
• stone • plaster • brick • slate • flagstones • fireplaces • exposed stone walls • brick walls • stone window ledges -
TECHNICAL INFO
Drying time: 15 minutes to 1 hour depending on temperature
Coverage: 15-20 square metres per litre , depending on the porosity of the material
Available in: 1 litre • 4 litre -
NSTRUCTIONS FOR USE
Preparation
Do not use in temperatures below 5°c/40°f or in very high humidity. Stone and brick protector should be used as supplied, without dilution, by brush, spray or roller.Application
Mix well before use.
For general applications on masonry, brickwork and stone, a single application will be sufficient.Caution
Always test on a trial area before application. Apply evenly and do not allow to pool in crevices. Test for clarity over dark colours.
NOTE: A chemical reaction could take place on some substrates such as glass, glazed surfaces, lead or aluminium. Mask these materials before application. In case of contact, rinse thoroughly with water immediately. - HOW TO'S
- COLOR LIST